ATC-106

ATC - 106A interface converter can send the signal RS–232C serial port data (TD) and receive data (RD) into two line balance of the half-duplex RS - 485 signal. It is the best choice of a remote Control device or point to multipoint communication bus.

Description

ATC – 106A interface converter can send the signal RS–232C serial port data (TD) and receive data (RD) into two line balance of the half-duplex RS – 485 signal. It is the best choice of a remote Control device or point to multipoint communication bus. The interface transition device don’t need ac/dc converter, it can be directly from the Data within the RS-232 port transmitter data (TD), request to Send (RTS) or Data terminal ready (DTR) to obtain power. It also have the Automatic Send Data Line Control function. When to Send and receive Data, do not need the RTS control. So the power supply from serial port and Automatic flow Control makes you don’t have to reset the hardware or install software. Improve the surge protection, can ensure the safety of the RS-485 network.

 

Reviews

There are no reviews yet.

Be the first to review “ATC-106”

Your email address will not be published. Required fields are marked *

Communication Parameters

Interface

Compatible with the EIA/TIA RS-232-C and RS-485 standard

RS-232

TD, RD, GND

RS-485

485+, 485-, GND

Working Mode

Point to point or point to multipoint, asynchronous half duplex(two line)

Direction Control

Automatic Send Data Line Control, automatic identification and control data transmission direction

Baud Rate

300-115.2kbps,automatic detection rate of serial port signals

Transmission Distance

RS-485 side 1200 meters (19.2 kbps), RS-232 side suggest no more than 10 meters

Connector

RS-232

DB-9 female

RS-485/422

DB9 male or 6-pin Terminal block

Load Capacity

Maximum connections of 32 nodes(64,128,256 can be customized)